How to Keep Your Pool Cleaner From Getting Tangled Up


Pool cleaners sure do make our lives much easier. They clean our pools for us keeping us from having to do the back breaking scrubbing ourselves. However, the hoses and cables on them can get tangled up, preventing them from doing their job.bigstock-Swimming-Pool-Cleaner-30807605

If you have tangles on the lines of your pool cleaner, you know how frustrating it is. They stop the pool cleaner from doing their job and they are often hard to get rid of. Today, we want to take a look at some of the most common tangle causes and what you can do to get rid of them once and for all. That way you can keep your pool cleaner from getting tangled up once and for all.

Stop Those Tangles

All is not lost if your pool cleaner is getting tangled up. There are many options for you to stop those tangles once and for all. Let’s take a look at several of the most common problems that cause tangles and what you can do to rid yourself of these tangles once and for all.

Stretch Out Those Hoses

If you are dealing with tangled hoses or even tangled power cables, the first thing you should try to do is to disconnect them and stretch them out across your lawn. Make sure you do this on a warmer day as the sun can help you get rid of those tangles.

Make sure they are stretched end to end and push those tangles out by hand and then allow the hoses and cables to bask in the sun for a few hours. The heat will help stop those tangles permanently.

Hose Length

Nothing can cause tangles more than a hose that is far too long for your pool. While you want a little bit of play in your hose, too much is overkill. This results in a hose that just floats in the water. This floating hose is free to move and for some reason loves to move around itself causing a tangle. Trim down your hose so that is just long enough for the farthest corner of your pool but don’t leave a lot of slack that can then tangle as it drifts in your water.

Check Your Connectors

The hose and swivel connectors are one of the most common sources for tangles out there. Over time these connectors and swivels can become stiff. This prevents the hose from turning as it should. When it won’t turn, tangles can easily form. If this is the source of the problem, you can stretch out the hoses as much as you want and they will return.

You can even add more swivels in your hose as well. Keep a close eye on where the tangles occur and then try adding a swivel in that location. This will give your hose even more play so it has room to move without getting tangled.

Mind Your RPMs

The wheels on your pool cleaner are designed to work at a specific RPM setting. Sometimes, the wheels can get set to run faster than they really should. Not only does this mean your pool cleaner won’t take as much time to do its cleaning, but it won’t do as good a job and your cables could get tangled as it speeds away across your pool. Lower those RPMs and see how your cables do.

Is Weather a Factor?

Sometimes, the problem is due to Mother Nature. Cables and hoses tend to tangle more if it is cooler outside. Check when it is a problem and if you are able don’t run your cleaner when it dips below 70°F.  That’s not always an option, however. If you must run your pool cleaner when it is colder, try stretching out the cables as we discussed earlier first to work out the kinks and then keep an

Clean Your Filters and Valves

You can’t forget that your pool cleaner is, well, cleaning your pool. That means that is collecting dirt and grime and any other muck off the sides and bottom of your pool. After a while the filters and valves on these cleaners can become caked with this nastiness. This can impact their performance and make them, well, misbehave, as they won’t move and pick up the contaminants as they should. When this happens tangles are known to occur.

While you don’t have to check it after every cleaning, we recommend you check it on a regular basis, checking the filters and valves removing any excess gunk that has accumulated. This one simple little piece of maintenance could end your tangling problem for good.

When All Else Fails

Sometimes, no matter what you do, the hose or cord will continue to get tangled. This is especially true if you have been dealing with tangled lines for a while. In the case of the hose, you can order a replacement from us. Even if your pool cleaner has been discontinued, there is still a good change you can find replacement parts, including the hoses. Plus we’ll take care of installing the new hose, priming it, measuring it and ensureing you will be tangle free for years to come.

Parting Thoughts

A tangled hose on a pool cleaner is never fun. It limits the functionality of your pool cleaner and can prevent it from getting the job done. I’m sure you don’t want a dirty pool. If you are dealing with a tangled pool cleaner, remember that there are solutions to the problem. If everything is working well on your pool cleaner only look at replacing the hose as a last resort.

Don’t forget, a tangled pool cleaner isn’t the end of the world. Trying the solutions above could take care of those pesky tangles once and for all so your pool cleaner does its job so you can enjoy a swim in a nice, clean pool.

nbws-water-logo

NORTH BAY WATER SERVICES, INC. SERVICING

BENICIA, VALLEJO, FAIRFIELD, VACAVILLE, DIXON, NAPA & ST. HELENA

6180 Egret Court, Suite A., Benicia, C A 94510

SINCE 1981

800-448-0362

Thank You for visiting our Blog!

Leave a comment

Your email address will not be published. Required fields are marked *